DBR05-X24 Remote Control Fireworks Firing System User Manual

Checkthe battery conditions on both remote and the Testthe system

You can try to fire a few ematches, or light up some LED lamps, make sure the system works properly.

Connect fireworks to the receivers correctly.

Make sure the remote is turned off while connecting fireworks

Make sure the receiver is turned off, and the switch is on TEST, while connecting fireworks.

Checkfireworks connection –

Makesure the key is on TEST  position

Turnon the receiver, the indicator close to the power switch is GREEN.

Indicatorsunder each channel will light up green if the fireworks connection is good. If it is not light up green, the connection is bad, please check and fix it.

When it is time to fire, pull out the antenna on the receiver,and turn the switch to FIRE position. The indicator close the power switch will turn RED.

Turn on the remote, also pull out the antenna, now you can fire the fireworks。

Fire fireworks one by one

Roll the wheel on the right side to get the cue number you want to fire.

Pressthe big red fire button to fire the selected Cue No.

After that, the remote will automatically plus 1, jump to the next cue number.

The indicator on the receiver has two colors. It would be GREEN when you turn on the remote. It will turn RED when one specific cue was fired. Un-fired cues would remain Green.

Fire all cues at one time

Roll the wheel up/down, till the LED display is “–”. Press the fire button, all 24 cues will fire at one time.

Automatically fire all cues one by one sequentially

Pressthe wheel inside the remote, the LED flashes, it is in the time setting mode.

Ifyou want all cues to fire one by one after every 7 seconds for example, roll the wheel to 7.

Pressthe wheel again, the digit 7 will be flickering, now it is in sequential fire mode.

Pressthe red fire button, all 24 cues will fire one by one sequentially from cue #1 to #24, after every 0.7 second.

timesetting: